Regency Bellavista Gas Fireplace B36X - Manual (Page 44)

44
Regency Bellavista™ B36X Gas Fireplace
INSTALLATION
OPTIONAL STAINLESS STEEL / BLACK ENAMEL
PANEL INSTALLATION
1) Remove the heat defl ector by removing the 2 screws securing the
heat defl ector to the top of the fi rebox (see Diagram 2).
2) Loosen the 2 baffl e screws - position the top panel inside the fi rebox
shown in Diagram 4. Slide slots of top panel into position under loosened
screws, retighten the screws.
Heat defl ector Diagram 2
Diagram 1
Diagram 3
Diagram 4
Slots on Top Panel
LEFT
BACK
TOP
RIGHT
STAINLESS STEEL PANEL INSTALLATION
Note: Panels must be installed prior to the installation of the log set and vermiculite.
Before installation, panels must be handled and cleaned as per instructions noted below:
Stainless Steel Panels Black Enamel Panels
• Stainless panels must be inspected for scratches and dimples prior
to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration. • Black Enamel panels must be inspected for scratches and dimples
prior to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
• To protect the fi nish during installation and handling - cotton gloves
MUST
be worn at all times while handling the panels (even when
removing protective coating).
•Stainless panels will discolor a little during normal operation.
This is normal and should not be considered a defect. • Black Enamel panels will discolor a little during normal operation. This
is normal and should not be considered a defect.
* All hand and fi nger marks MUST be cleaned off with a soft cloth and
a stainless steel cleaner. Most stainless steel cleaners leave a fi lm/
residue on the surface of the panels. Use an ammonia based cleaner
(ie. glass cleaner) to remove this fi lm before applying heat to the unit.
Failure to do this will result in burn stains on panels which you
will be unable to remove.
Not protected by product warranty.
* All hand and fi nger marks MUST be cleaned off with a soft cloth. Use
an ammonia based cleaner (ie. glass cleaner) to remove any fi ngerprints
before applying heat to the unit.
Failure to do this will result in burn stains on panels which you
will be unable to remove.
Not protected by product warranty.
3) Slide back panel in over burner - be careful not to scratch panel on
back log tray, burner, or top panel when positioning.
Diagram 5