Roberts Gorden Vacuum Assisted Linear - Manual (Page 5)

TABLE OF FIGURES
Figure 1: Side and Back Panel Label Placement............2
Figure 2: Top Panel Label Placement.............................3
Figure 3: Linear & Double Linear, Horizontal Mounts .....6
Figure 4: Linear & Double Linear, One Side Reflector....6
Figure 5: Linear & Double Linear, Two Side Reflectors ..6
Figure 6: Linear & Double Linear, 45° Mount..................6
Figure 7: Linear & Double Linear, 2 Foot Deco Grille .....7
Figure 8: Linear & Double Linear, Protective Grille.........7
Figure 9: Undershield .....................................................7
Figure 10: Linear & Double Linear, Venting ....................7
Figure 11: U-Tube, Horizontal Mount..............................8
Figure 12: U-Tube, One Side Reflector...........................8
Figure 13: U-Tube, Two Side Reflectors.........................8
Figure 14: U-Tube, Full 45° Mount..................................8
Figure 15: U-Tube, Opposite 45° Tilt ..............................9
Figure 16: U-Tube, Protective Grille................................9
Figure 17: U-Tube, Venting.............................................9
Figure 18: Critical Hanger Placement ...........................12
Figure 19: Linear General Assembly Overview.............14
Figure 20: Linear Layout Overview ...............................15
Figure 21: Double Linear General Assembly
Overview ......................................................17
Figure 22: Double Linear Layout Overview...................18
Figure 23: U-Tube Assembly Overview ........................27
Figure 24: U-Tube Layout Overview .............................28
Figure 25: Multiburner Damper Flange Installation .......35
Figure 26: Typical Manifold Layout (Linear and
U-Tube Configuration)..................................36
Figure 27: U-Tube (Horizontal) .....................................48
Figure 28: U-Tube (Angle Mounted) .............................49
Figure 29: Linear ...........................................................49
Figure 30: Individual Flue Connection Detail ................51
Figure 31: Flue Connection Dimensions .......................51
Figure 32: Fresh Air Intake Spigot ................................52
Figure 33: Air Supply with Flue Configurations .............52
Figure 34: Gas Connection with Stainless Steel Flex
Connector.....................................................54
Figure 35: Sequence of Operation Chart ......................58
Figure 36: Burner Cup Position.....................................61
Figure 37: Linear and U-Tube Specifications................74