Runco LIGHTSTYLE LS-10I - Manual (Page 103)

External Control
Runco LS-10i Installation/Operation Manual 87
PRE
L
IMINAR
Y
6.2
Using HDMI CEC
Messages The LS-10i accepts and can respond to CEC command messages from a disc player,
satellite receiver or DVR/set-top box via an HDMI connection. Using CEC, the LS-10i can
perform the following actions:
• Turn itself on and select the correct input when the source component initiates
playback of a disc or recorded program.
• Turn the source component on when you switch to its corresponding input on the
LS-10i.
• Turn the source component off when the LS-10i is turned off (unless the source
component is in playback mode).
• Change its OSD language when a similar change is made at the source.
To use CEC, connect your CEC-compatible sources to the HDMI inputs on the LS-10i.
Set the HDMI CEC option to On (refer to HDMI CEC on page 67). Additional steps may
be needed to enable CEC at the source. Refer to the documentation for your source
device for more information.
CEC Command List Table 6-4 lists the CEC commands supported by the LS-10i.
Table 6-4. CEC Commands Supported by the LS-10i
Opcode Value
Feature Abort 0x00
Image View On 0x04
Set Menu Language 0x32
Standby 0x36
User Control Pressed 0x44
User Control Released 0x45
Active Source 0x82
Give Physical Address 0x83
Report Physical Address 0x84
Request Active Source 0x85
Set Stream Path 0x86
Device Vendor ID 0x87
Vendor Command 0x89
Give Device Vendor ID 0x8C
Menu Request 0x8D
Menu Status 0x8E
Give Device Power Status 0x8F
Report Power Status 0x90
Get Menu Language 0x91