Runco LIGHTSTYLE LS-10I - Manual (Page 35)

Installation
Runco LS-10i Installation/Operation Manual 19
PRE
L
IMINAR
Y
Vertical and Horizontal
Position Proper placement of the projector relative to the screen will yield a rectangular,
perfectly-centered image that completely fills the screen.
Ideally, the projector should be positioned perpendicular to the screen and in such a way
that the lens center is aligned with either the top or bottom edge of the screen area, and
centered horizontally. See Figure 3-3.
Figure 3-3. Projector Placement
Lens Shift You can use the lens shift controls on the projector to center the image on the screen.
Lens shift is generally expressed as a percentage of the screen height or width, as shown
in Figure 3-4 and Figure 3-5.
Figure 3-4. Vertical Lens Shift (Example Only)
Screen
Height
Projection Distance
Ceiling
x
Lens Center Lens Center
Ceiling Installation
Screen Height
Floor
Lens Center
Projection Distance
Floor Installation
Lens Center
x
50% Height
Lens Shift
(0.5 x H)
100% Height
Lens Shift
(1.0 x H)
Screen Center
0%
Note: This is a general example of lens shift. Lenses vary in their shift capabilities. No particular
lens or projector is used in this example.