Runco LIGHTSTYLE LS-10I - Manual (Page 62)

Operation
46 Runco LS-10i Installation/Operation Manual
PRE
L
IMINAR
Y
Main The LS-10i Main Menu, shown in Figure 4-2, provides access to the most
commonly-used projector functions.
Figure 4-2. LS-10i Main Menu
➤
1. For best results, Runco recommends that you set
ConstantContrast to Off before adjusting Brightness, Contrast and
other image quality settings in this menu (refer to
ConstantContrast on page 57). After you have completed the
initial calibration, set ConstantContrast to On if desired.
2. Image controls only operate on the active source. To adjust the PIP
source, switch to the PIP source (thereby making it the active
source), adjust the controls and then switch back.
Note