Runco LIGHTSTYLE LS-10I - Manual (Page 44)

Installation
28 Runco LS-10i Installation/Operation Manual
PRE
L
IMINAR
Y
Adjusting the Projection
Angle
If the LS-10i is ceiling-mounted and the screen is significantly lower than the projector, you
can tilt the projector at a slight angle by adjusting the ceiling mount.
The projector can be rotated (side-to-side) up to 360 degrees and mounted without it
affecting performance. However, to ensure optimal performance of the lamp, limit the
front-to-back tilt of the projector to ±20 degrees; see Figure 3-7.
Figure 3-7. Mounting Angle Ranges (Front-to-Back and Side-to-Side)
If you do this, you may need to vertically shift the image to compensate. For detailed
instructions, refer to Primary Lens Adjustments on page 38.
➤
± 360º
± 20º