Runco LIGHTSTYLE LS-10I - Manual (Page 31)

Installation
Runco LS-10i Installation/Operation Manual 15
PRE
L
IMINAR
Y
3.2
Quick Setup Table 3-1 gives a quick overview of the LS-10i installation process. The sections following
this one provide detailed instructions.
Installation should be performed by a qualified custom video
installation specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer
to page...
1 Choose a location for the projector 16
2 Install anamorphic lens mounting assembly (optional) 21
3 Mount the projector 27
4 Connect signal sources to the LS-10i 30
5
Connect external controller to RS-232 port and/or IR repeater
system (optional) 35
6
Connect 12-volt trigger output to retractable screen or other,
+12V trigger-activated equipment (optional) 36
7 Apply power to the projector 37
8
Primary lens adjustments: projected image size (zoom), position
(shift) and focus 19, 38
9 Change the OSD Language (optional) 39
10
For rear-screen and/or ceiling-mount installations, select the
proper picture orientation 39
11 Install and adjust secondary anamorphic lens (optional) 40
12
Projector calibration: adjust the following for each input; save
settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Sharpness
• White Balance 46
Note