Runco LIGHTSTYLE LS-10I - Manual (Page 83)

Operation
Runco LS-10i Installation/Operation Manual 67
PRE
L
IMINAR
Y
Trigger 1: Select Trigger 1 from the Control menu to specify when the Trigger 1 port
outputs 12 volts. There is a three-second delay before activation to prevent operation
while selecting an aspect ratio.
• AutoScope causes the port to output 12 volts whenever the the Cinema or Virtual
Cinema aspect ratio is active.
• Lamp causes the port to output 12 volts whenever the lamp (LED RGB assembly) is
on.
• 4:3 causes the port to output 12 volts whenever the 4:3 aspect ratio is chosen. The
output stops if PIP is enabled (PIP source is set to anything other than off).
• RS232 causes the port to output 12 volts when an RS232 screen trigger 1 “on”
command is received and stop when a trigger 1 “off” command is received. The 12 volt
output also stops when the projector is turned off.
Trigger 2: Select Trigger 2 from the Control menu to configure the Trigger 2 output.
Trigger 2 operates identically to Trigger 1.
HDMI CEC: This control chooses whether or not the LS-10i responds to HDMI CEC
control messages from a disc player, set-top box or other HDMI source. The default
setting is On. For more information about CEC, refer to Using HDMI CEC Messages on
page 87.
Language Select Language from the Main Menu to change the OSD Language.
The LS-10i can display the menus in English, French, German, Italian, Spanish, Swedish,
Portuguese or Russian.
Press or to select a language. Then, press ENTER to confirm your selection.