Ricoh RDC-5000 - Manual (Page 59)

57
Advanced Shooting
3
Auto Mode
This mode automatically discharges the flash when it detects low ambient light or
backlighting. This mode allows you to respond appropriately to a wide range of
standard shooting conditions.
q
Set the mode dial to [ ].
w
Press the flash mode button to select
mark.
This auto mode is now set.
The mark, which signifies auto mode,
appears only on the LCD monitor. If the mark is
not shown in the LCD panel, the camera is in
auto mode.
When you press the shutter release button, this
mode automatically discharges the flash when
the camera detects low ambient light or
backlighting. The flash LED will light (red)
when you press the shutter release button
lightly.
Note
• The flash LED will pulse while the flash is charging and the LCD monitor will
momentarily blacken. You will not be able to shoot during this interval.
Important
Note
• Subjects shot from less than 0.4 m (15.8 inches) away may be over-
exposed and appear bleached out in the picture. To avoid this, switch to
the flash off mode.
How to Cancel the Auto Mode
Press the flash mode button and switch to another mode.
1 8 0 0 x 1 2 0 0 N
1 2