Ricoh RDC-5000 - Manual (Page 96)

94
Erasing a File (Image)
This section explains how to erase recorded files. There are three ways to erase files:
(1) erase, one selected file is erased at a time
(2) erase all, all files are erased at once, and
(3) format, files on a SmartMedia memory card that have been used on another device
are erased and the card is formatted for use with this camera.
Note • Files on a write-protected SmartMedia memory card cannot be erased
unless the write protect pad is removed from the card. See “Protecting
Against Accidental Writing” (p.31).
Only the pictures that have been taken with this camera can be erased.
• Depending on the SmartMedia capacity, it may take a short time to erase
a file after turning on the power or changing the mode dial.
Operation Flow
To erase image files, follow the steps below:
Slide the power switch on and set the mode dial to [ERASE].
Set the mode dial to [ ].
Select the internal memory or the SmartMedia of the source file to erase.
See “Inserting a SmartMedia Memory Card” (p.32)
Select the modes from Erase, Erase All Images, Erase Selected
Files (Images).
Select a file for the modes of Erase, Erase Selected Files (Images).
Erase a file.
See:
“Erase” (p.95)
“Erase All Images” (p.96)
“Erase Selected Files (images)” (p.97)
Select a File
Erase
Select the Erase Mode
Select a source file to erase
Turn on the Camera
Switch To the Erase Mode