Omron CS CJ1W-ETN21 - Manual (Page 55)

31
Example Application Section 2-9
2. Destination Mail Address Setup
3. Send Condition Setting 1
Contents of E-mail Body • Including User-set Data in E-mail Body
• Including Error Log Information in E-mail Body
• Including Status Information in E-mail Body
Attached File Information Example:
Sending the 10 words of data from W300 to W309 as an attached file called
W300.CSV.
Mail Trigger Condition
Settings • Send on the Rising Edge of the Dedicated Control Bit (Mail Send Switch)
Note The Mail Send Switch is bit 03 of word n in the CIO Area words allocated to
the Ethernet Unit as a CPU Bus Unit. (n = 1500 + 25
× unit number)
• Send when a Specified Word's Value meets a Preset Condition
Example: Send e-mail when the content of D00300 is 500.
• Send on the Rising or Falling Edge of a Specified Bit
Tab Item Setting
DNS IP Address 10.56.3.24
Port No. 53 (default value)
Retry timer 10 s (default value)
Tab Item Setting
Mail Address Mail address 1 [email protected]
Tab Item Setting
Send Mail Mail address Address 1
Tab Item Setting
Send Mail Send user data Selected
User defined mail address Set the leading address of the
words in I/O memory that contain
the user-set ASCII data.
Tab Item Setting
Send Mail Send Error Log information Selected
Tab Item Setting
Send Mail Send status information Selected
Tab Item Setting
Send Mail Send file data or I/O memory
data Send file data or I/O memory data
selected; I/O data (CSV) selected
Attached file name W300
I/O memory data Area: W; Address: 0; Size: 10
Tab Item Setting
Send Mail Mail trigger type Bit value change
Tab Item Setting
Send Mail Mail trigger type Word value change
Area: D
Address: 300
Value: 500
State: =