Onkyo CR-N1 - Manual (Page 18)

18
Getting connected
• Connect speakers only as shown here.
Incorrect connections may damage the
CR-N1 and the speakers.
• The minimum impedance for each
speaker is 4 ohms.
• Unnecessarily long, or very thin speaker
cables may affect the sound quality and
should be avoided.
• Do not connect more than one speaker to
each pair of terminals.
• Turn off the CR-N1 before connecting any
speakers. Failure to do so may damage
the CR-N1 or the speakers.
• See page 20 for information on connect-
ing the Onkyo D-N1 speakers.
Preparing the speaker cables
1. Strip 15 mm (5/8") of insulation from the
ends of the speaker cables, as shown.
2. Twist the bare wires, as shown.
• Do not connect the AC power cord to a
wall outlet until you’ve completed all
other connections, including antenna (see
page 23).
Connecting the speakers
Speakers must be connected only as shown
here.
Make sure that each (+) speaker terminal is
connected to the correct (+) CR-N1 SPEAKERS
terminal, and that each (–) speaker terminal
is connected to the correct (–) CR-N1 SPEAK-
ERS terminal. Incorrect speaker wiring will
affect the sound quality and may damage
the CR-N1 or the speakers.
Connecting speakers
15 mm
(5/8")
Right speaker Left speaker
– + – +