Onkyo CR-N1 - Manual (Page 6)

6
Declaration of Conformity
We, ONKYO EUROPE
ELECTRONICS GmbH
INDUSTRIESTRASSE 20
82110 GERMERING,
GERMANY
GERMERING, GERMANY
ONKYO EUROPE ELECTRONICS GmbH
I. MORI
declare in own responsibility, that the ONKYO product described
in this instruction manual is in compliance with the corresponding
technical standards such as EN60065, EN55013, EN55020 and
EN61000-3-2, -3-3.
Precautions
For European model
This unit contains a semiconductor laser sys-
tem and is classified as a “CLASS 1 LASER
PRODUCT”. So, to use this model properly,
read this Instruction Manual carefully. In case
of any trouble, please contact the store
where you purchased the unit.
To prevent being exposed to the laser beam,
do not try to open the enclosure.
This label on the rear panel states that:
1.
This unit is a CLASS 1 LASER PRODUCT and
employs a laser inside the cabinet.
2. To prevent the laser from being exposed,
do not remove the cover. Refer servicing
to qualified personnel.
For British model
Replacement and mounting of an AC plug on
the power supply cord of this unit should be
performed only by qualified service personnel.
IMPORTANT
The wires in the mains lead are coloured in
accordance with the following code:
Blue : Neutral
Brown : Live
As the colours of the wires in the mains lead
of this apparatus may not correspond with
the coloured markings identifying the termi-
nals in your plug, proceed as follows:
The wire which is coloured blue must be con-
nected to the terminal which is marked with
the letter N or coloured black.
The wire which is coloured brown must be
connected to the terminal which is marked
with the letter L or coloured red.
IMPORTANT
A 5 ampere fuse is fitted in this plug. Should
the fuse need to be replaced, please ensure
that the replacement fuse has a rating of 5
amperes and that it is approved by ASTA or
BSI to BS1362. Check for the ASTA mark or
the BSI mark on the body of the fuse.
IF THE FITTED MOULDED PLUG IS UNSUITABLE
FOR THE SOCKET OUTLET IN YOUR HOME
THEN THE FUSE SHOULD BE REMOVED AND
THE PLUG CUT OFF AND DISPOSED OF SAFELY.
THERE IS A DANGER OF SEVERE ELECTRICAL
SHOCK IF THE CUT OFF PLUG IS INSERTED
INTO ANY 13 AMPERE SOCKET.
If in any doubt, please consult a qualified
electrician.
Trademarks
Apple, Mac, Power Macintosh, and Power-
Book are registered trademarks and iBook
and iMac are trademarks of Apple Corpora-
tion, Inc. Microsoft and Windows are regis-
tered trademarks of Microsoft Corporation,
Inc.
Memory backup
The CR-N1 uses a special battery-less memory
backup system in order to retain the radio
presets and other settings when it’s
unplugged or in the case of a power failure.
Although no batteries are required, the
CR-N1 must have been plugged in in order to
charge the backup system. Once it has been
charged, the CR-N1 will retain its settings for
several weeks, although this depends on the
environment and will be shorter in humid cli-
mates.
“CLASS 1 LASER
PRODUCT ”