Onkyo CR-N1 - Manual (Page 43)

43
Listening to the radio
3 While “– –” is flashing, use the Tuning
(
/ ) buttons to select a
preset from 1 through 30.
When you select a preset that already
contains a station, the preset number
flashes quickly. You can overwrite such
presets by continuing with this procedure.
Alternatively, select an available preset.
4
While the preset number is flashing,
press the MEMORY button to store the
selected preset (the MEMORY indicator
disappears and the preset number stops
flashing).
Note that you must press the MEMORY
button while the preset number is flash-
ing, otherwise, you’ll have to start the
procedure again at step 2.
The message “FULL” appears if you
attempt to store more than 30 presets.
If the tuned FM station supports RDS Pro-
gram Service Names (PS), the station’s
name is displayed instead of its frequency.
Preset stations can be selected as follows.
1
To select either FM or AM, press the
INPUT button on the CR-N1 repeatedly
until “FM” or “AM” appears on the dis-
play, or press the FM or AM button on
the remote controller.
2
Use the Tuning ( / ) but-
tons, or the PRESET ( / ) buttons on
the remote controller to select the pre-
sets.
INPUT
MEMORY
AM
FM
PRESET ( / )
STEREO
MHz
MEMORY
STEREO
MHz
AUTO
Selecting preset stations
or
Remote controller
Remote controller