Onkyo CR-N1 - Manual (Page 57)

57
Using USB
Sound control panel confirmation
In order to output audio from your Macin-
tosh via USB, you must set the audio output
as follows.
1 Open the Sound control panel.
2
Select Output, and make sure that
“Choose a device for sound output:” is
set to Built-in, as shown.
Mac OS 9.0.4
Mac OS 9.1
3
Play an AIFF file or something in order to
confirm that the CR-N1 is outputting
sound properly.
Note that the device list you see on your
Macintosh will no doubt be different to
that shown here due to configuration
and system differences.
If no sound is heard, disconnect the USB
cable from the CR-N1, reconnect it, and
then check again.
Using Platinum Sounds
In order to listen to Platinum Sounds via USB,
follow the procedure below. If you do not
follow this procedure, Platinum Sounds may
not work properly.
1 Disconnect the CR-N1 from your Macin-
tosh’s USB port.
2
Open the Appearance control panel.
3
Click the Sound tab, and set “Sound
track” to None, as shown.
4
Reconnect the CR-N1 to your Macin-
tosh’s USB port.
5
Set the “Sound track” to Platinum
Sounds, as shown.
6
Close the Appearance control panel.