Omron NT20M - Manual (Page 125)

121
4. Input the name, using up to 8 normal characters, of the file in which the
data received is to be stored, and then press the Enter Key.
5. Input a title of up to 28 characters, and press the Enter Key. The follow-
ing message will be displayed and the Support Tool will wait for the data
to be sent from the PROM writer.
6. Transmit the data from the PROM writer.
7. When the data has been received, a message will be displayed. To re-
turn to step 1, press any key.
Note 1. When receiving data from a PROM writer, you need enough disk space to
be able to save a work file used for receiving the data and a storage file
for saving the data received. Be sure, therefore, to reserve at least 256 K
for the NT20M and 512 K for the NT600M.
2. If the memory capacity setting for the file in which the data received is
stored differs from memory capacity setting in Tool Settings, then the file
will not be displayed even if you return to the File Selection Display. If that
happens, change the setting in Tool Settings.
3. If you designate a new file with the same name as an existing file, a mes-
sage will appear indicating that the file name already exists, and asking
you if you wish to overwrite the existing file. If it is overwritten, any data
Receiving Data from a PROM Writer Section 7-4