Omron NT20M - Manual (Page 44)

40
Number of character
digits (Char; See Note) Set the number of character digits to be displayed on
the screen.
Character size (Size) Set the character size to be used for each 1-byte
characters.
Scale Set the scale for characters to be displayed on the
screen.
Display attributes
(Attr.) Set display attributes for the screen. Refer to page 24
for examples of how attributes are displayed on screen.
Note For contents registered in the memory table, only the number of digits that
have been set will be displayed. Each normal character requires one digit
and each mark requires 2 digits.
8. Set the display position. When the display position has been set, you
can return to set another character string display or you can continue
pressing the Escape Key to return to the Initial Edit Display.
Deleting and Modifying Direct connection character string displays are deleted or modified from the
display shown in step 1. above. Select the number of the character string
table and then specify DELETE or MODIFY. The modification procedure is
basically the same as the creation procedure given above.
2-4 Lamps
An indicator lamp can be created by setting the lamp size, display position,
and a label. You can set a maximum of 64 lamps per screen for the NT20M
and 128 for the NT600M.
The procedure for creating lamps depends on whether or not direct connec-
tion is ON or OFF in the Tool Settings. Both procedures are given below.
2-4-1 Normal Lamps
If you select LAMP from the Initial Edit Display, the Initial Lamp Display will
appear.
Initial Lamp Display
Lamp Shape Either square or circular must be specified for the lamp shape.
Lamps Section 2-4