Omron NT20M - Manual (Page 21)

16
“No” to save time. You can manually rewrite the screen by pressing the Tab
Key during operation.
Temporary Directory The Support Tool will create a temporary work file when creating screens or
transferring data to or from ROM. Most write operations are performed on
this temporary file. To increase overall operating speed, this file should be
created on your hard disk or in RAM.
Tool Settings File File settings are saved in the root directory for the Support Tool, i.e., the di-
rectory from which the Support Tool is started. The file name is
NTMSET.ENV. If this file exists in the root directory when the Support Tool is
started, the setting in the file will be read and the Support Tool will operate
according to them. Tool settings files can be used to eliminate the need to
reset tool setting each time the Support Tool is started.
Display Grid A grid can be displayed to aid in positioning objects when creating screens.
The Tool Settings can be used to disable the grid or to set its size to 8, 16, or
32 dots. The grid size can also be set to the same size as a touch switch by
specifying “TouchSW.” The grid, once enabled, can be turned ON or OFF as
desired during operation. Refer to page 12 for details.
1-14 Environment Settings
A modified version of the Tool Settings can be accessed from the Initial Edit
Display. The following display will appear when SET ENV is specified.
Set the PT operating environment as described in the following table.
Environment Settings Section 1-14