Omron NT20M - Manual (Page 77)

73
3. You can move the cross-shaped cursor to the starting point of the desig-
nated polyline and then make additions or modifications in the same
way as when creating new polylines.
2-10 Circles
Circles can be created on the screen. The amount of circle data for a screen
depends only on the amount of memory remaining. Select GRAPHIC from
the Initial Edit Display to access the Graphic Input Display and then select
CIRCLE. The Initial Circle Display will appear.
Initial Circle Display
2-10-1 Creating New Circles
1, 2, 3... 1. Specify CREATE.
2. Designate the center of the circle. The center of the circle will be indi-
cated by an x.
3. Designate the radius and press the Enter Key. The entire circle must be
contained within the display area both when creating it and when dis-
playing it on the PT screen.
To return to step 1, press the Escape Key.
Circles Section 2-10