Oki B2500 Series - Manual (Page 31)

B2520 / B2540
- 26 -
6 - Parameters/Setup
Technical Parameters
As delivered your machine is preset by default. However,
you may adjust it to meet your requirements by resetting
the technical parameters.
To set the technical parameters:
29 - SETUP / TECHNICALS
1 Select the desired parameter and confirm with OK.
2 With the keys
or , modify the parameter
settings by following the table below and press OK.
Parameter Signification
1 - Scanning mode Default value of the scan mode
resolution for the documents to be
transmitted.
2 - TX header If this parameter is on, your header
will appear on all documents sent
to your subscribers with your name,
number, date and number of
pages.
Warning: If you send a fax from the
document loader, the transmission
header will not appear on the
document your correspondent
receives.
3 - TX speed Transmission speed for outgoing
documents.
For a quality telephone line
(compatible, no echo),
communications occur at
maximum speed.
However, it may be necessary to
restrict the transmission speed for
some calls.
4 - Echo protect If this parameter is on, the on-line
echo will be reduced during long
distance calls.
6 - EPT mode For some long distance calls
(satellite), the on-line echo may
disturb the call.
7 - COM. display Choice between transmission
speed displayed or number of the
page in progress.
8 - Eco energy
(ECO) Choosing the printer standby delay:
the printer will switch to standby
after a delay (in minutes) of NON-
operation or during the period of
time of your choice.
10 - RX header If this parameter is on, all
documents received by your fax will
include the subscriber’s header
with his name, number (if available)
fax print date and the page number.
11 - RX speed Transmission speed for incoming
documents.
For a quality telephone line
(compatible, no echo),
communications occur at
maximum speed.
However, it may be necessary to
restrict the transmission speed for
some calls.
12 - Rings Number of rings to automatically
start your machine.
13 - Discard size The Discard Size parameter only
defines the printing of received
faxes . The number of lines of a
document can be too high for the
printing paper format. This
parameter defines the threshold
beyond which the extra lines are
printed on a second page. Bellow
this threshold, extras lines are
deleted.
If you choose With, the threshold
is set on 3 centimeters.
If you choose Without, the
threshold is set on 1 centimeter.
20 - E.C.M. This parameter helps correct the
calls made on disturbed telephone
lines. It is used when the lines are
weak or too noisy. Transmission
times may be longer.
25 - TEL Impedance This parameter lets you choose
between a complex impedance and
a 600 Ohm impedance, depending
on the telephone network your
terminal is connected to.
73 - Improve rep @ This parameter lets you
automatically register the Internet
address of your subscribers fax
during a call (if available).
Parameter Signification