Oricom DECT MI40 - Manual (Page 30)

59 of 72
Out of Range Warning
When the handset is too far away from the base during standby and
the link is lost with the base, the display will show BS SEARCH and
the icon will blink.
• Bring the handset nearer to the base so that the signal gets
stronger.
• When the signal between the handset and base re-establishes,
the display will go to standby and the icon will be steady.
When the handset is too far away from the base during a call, user
will hear an alert tone through the earpiece.
• Bring the handset closer to the base so that the signal gets
stronger.
• If you fail to bring the handset back in range with the base,
your call would be disconnected.
Auto Answering
When the function is activated, user is able to answer a call by lifting
the handset out of the base cradle without having to press the
key.
•
Press . Use to scroll through the menu until the display
reads SETTINGS.
•
Press . Use to scroll through the menu until the display
reads AUTO ANS.
•
Press .
• To activate:
o Use to select ON.
o Press . User can answer a call by lifting the handset out of
the base cradle without having to press the key.
• To de-activate:
60 of 72
o Use to select OFF.
o Press . User will need to press the key to answer a
call no matter the handset is on the base cradle or out of the
base cradle.
Recall Timing
Recall timing default settings are: Australia 100ms and New Zealand
600ms. You should not need to change these settings.
If when you are using network services or a PBX the button
does not work you can select a different setting.
•
Press . Use to scroll through the menu until the display
reads SETTINGS.
•
Press . Use to scroll through the menu until the display
reads FLASH TIME.
• Press . Use to select from the two durations choose Flash
1 for Australia and Flash 2 for New Zealand.
•
Press on a selection to confirm and exit to FLASH TIME.
•
Press and hold will exit to standby.
Handset Name
If you choose to you may programme each handset with its own
name to be displayed during standby.
•
Press . Use to scroll through the menu until the display
reads DISPLAY.
• Press . Use to scroll through the menu until the display
reads LABEL.