Omega ILD44-UTP - Manual (Page 25)

21
Input Type (Process)
ENTER INPUT TYPE MENU:
Press a 1) Press a, if necessary, until CNFG prompt appears.
Press d 2) Display advances to INPT Input Menu.
Press d 3) Display flashes T.ç, RTD or PROC (Thermocouple, RTD or
Process). If the displayed input type is PROC, press a to skip to
step 6 ( PROC stops flashing).
PROCESS SUBMENU:
Press b 4) Scroll through the available selection to PROC (flashing).
Press d 5) Display shows STRD stored message momentarily and then
PROC (not flashing).
Press d 6) Display flashes previous Process type selection. i.e. 0-10
(see below for Process types selection).
Press b 7) Scroll through the available Process types to the selection of
your choice.
Press d 8) Display shows STRD stored message and then advances to
RDG Reading Configuration Menu.
Process Types: 100 mV 1 V 10 V 0 – 20 mA
Display: 0-0.1 0-1.0 0-10 0-20
For 4-20 mA Input select 0-20 mA then adjust the Input/Reading accordingly.
To adjust 4-20 mA input, see example under INPUT/READING submenu. The
factory preset value is 4-20 mA.
3.2.5 Reading Configuration
Figure 3.4 Flow Chart for Reading Configuration Menu
It is recommended that you put the
controller in the Standby Mode for any
configuration change other than Setpoints &
Alarms.