Omega ILD44-UTP - Manual (Page 59)

55
TEMPERATURE UNIT SUBMENU:
Includes a byte in the data string to indicate whether reading is in Celsius or
Fahrenheit.
Press d 50) Display flashes previous selection for UNIT.
Press b 51) Scroll through the available selections: NO, YES.
Press d 52) Display shows STRD stored message momentarily and then
advances to ADDR only, if it was changed, otherwise press a to
advance to ADDR Address Setup Submenu.
ADDRESS SETUP SUBMENU:
This menu is applicable to the RS-485 Option only.
Press d 53) Display advances to “Address Value” (0000 to 0199) Submenu.
ADDRESS VALUE SUBMENU:
Press d 54) Display flashes 1
st
digit of previously stored Address Value.
Press b & c 55) Press b and c to enter new “Address Value”.
Press d 56) Display shows STRD stored message momentarily and then
advances to TR.TM only, if it was changed, otherwise press a to
advance to TR.TM Transmit Time Interval Submenu.
TRANSMIT TIME INTERVAL SUBMENU:
This menu is applicable if “Continuous” Mode was selected in the “Data
Flow Mode” Submenu and the device is configured as an RS-232C
Standard device. Also, one or more options under the Data Format
Submenu must be enabled.
Press d 57) Display advances to “Transmit Time Value” Submenu.
TRANSMIT TIME INTERVAL VALUE SUBMENU:
Determines the interval at which data will be emitted to the RS-232 Serial Bus
when the instrument is in Continuous Data Flow Mode.
Press d 58) Display flashes 1 st digit of previous “Transmit Time Value” in
seconds.
Press b & c 59) Press b and c to enter new “Transmit Time Value”, e.g.
0030 will send the data every 30 seconds in Continuous Mode.
Press d 60) Display shows STRD stored message momentarily and then
advances to COLR only, if it was changed, otherwise press a to
advance to COLR Color Display Selection Menu.
For more details, refer to the Communication Manual available at the
website listed in the cover page of this manual or on the CD-ROM
enclosed with your shipment.