Omega ILD44-UTP - Manual (Page 34)

30
ANALOG OUTPUT ENABLE/DISABLE SUBMENU:
Press b 5) Scroll though the available selection until ENBL displays to
use Analog Output Retransmission (output proportional to the
input signal).
Press d 6) Display shows STRD stored message momentarily and then
advances to CURR or VoLT Submenu only if it was changed,
otherwise press a to advance to CURR or VoLT
Current/Voltage Submenu.
If DSBL Analog Output Disabled was selected, all submenus of Analog
Output Menu will be skipped and the meter will advance to ALR2 Alarm 2
Menu. If ENBL Analog Output Enabled was selected, Output 1 would be
automatically Disabled, and reassigned as Analog Output.
CURRENT/VOLTAGE SUBMENU:
Press d 7) Display flashes CURR Current or VoLT Voltage.
Press b 8) Scroll through the available selection: Current or Voltage
(Example
VoLT ).
Press d 9) Display shows STRD stored message momentarily and then
advances to RD1 Submenu only if it was changed, otherwise
press a to advance to RD1 Reading 1 Submenu.
READING 1:
Press d 10) Display flashes 1 st digit of previous “Reading 1” value.
Press b & c 11) Enter “Reading 1” value. (Example 0000)
Press d 12) Display advances to OUT.1 Out 1 Submenu.
OUT 1:
Press d 13) Display flashes 1 st digit of previous “Out 1” value.
Press b & c 14) Enter “Out 1” value. (Example 00.00)
Press d 15) Display advances to RD!2 Reading 2 Submenu.
READING 2:
Press d 16) Display flashes 1 st digit of previous “Reading 2” value.
Press b & c 17) Enter “Reading 2” value. (Example 9999)
Press d 18) Display advances to OUT.2 Out 2 Submenu.
OUT 2:
Press d 19) Display flashes 1
st t digit of previous “Out 2” value.
Press b & c 20) Enter “Out 2” value. (Example 10.00)
Press d 21) Display advances to the ALR2 Alarm 2 Menu.
The above example is for 0-10 V of the entire range of the Process Input
and Analog Output. For 0-20 mA output you need to set “Analog Type” to
Current and OUT 2 to 20.00.