Omega ILD44-UTP - Manual (Page 66)

62
PART 5
FACTORY PRESET VALUES
Table 5.1 Factory preset value
MENU ITEMS FACTORY PRESET VALUES NOTES
Set Point 1 (SP1) 000.0
Set Point 2 (SP2) 000.0
Input:
Input Type (INPT)
TC, type K
Reading Configuration (RDG):
Decimal Point (DEC.P)
FFF.F
Temperature unit (TEMP) °F
Filter value (FLTR) 0004
Alarm 1 & 2:
Alarm 1 (ALR1), Alarm 2 (ALR2)
Disable (DSBL)
Absolute/Deviation (ABSO/DEV) Absolute (ABSO)
Latch/Unlatch (LTCH/UNLT) Unlatch (UNLT)
Contact Closure (CT.CL) Normally Open (N.O.)
Active (ACTV) Above (ABOV)
Alarm At Power On (A.P.ON) Disable (DSBL) Alarm 1 only
Alarm Low (ALR.L) -100.0
Alarm High (ALR.H) 400.0
LOOP:
Loop Break Time (LOOP)
Disable (DSBL)
Loop Value (B.TIM) 00:59
Reading Adjust Value (R.ADJ) 000.0
ANALOG OUTPUT (Retransmission):
Analog Output (ANLG)
Enabled (ENBL)
Current/Voltage (CURR/VOLT) Voltage (VOLT)
Scale and Offset Reading: 0 - 999.9 cts, Output: 0 - 10 V
OUTPUT 1 & 2:
Self (SELF)
Disabled (DSBL) Output 1 only
% Low Value (%LO) 0000 Output 1 only
% High Value (%HI) 0099 Output 1 only
Control Type (CTRL) On/Off
Action Type (ACTN) Reverse (RVRS)
Dead Band (DEAD) 020.0
PID Auto (AUTO) Disable (DSBL)
Anti Integral (ANTI) Disable (DSBL) Output 1 only
Proportion Value (PROP) 020.0
Reset Value (REST) 0180 Output 1 only
Rate Value (RATE) 0000 Output 1 only
Cycle Value (CYCL) 0007
Damping Factor (DPNG) 0003