Tyco 1540 - Manual (Page 43)

Parameter Parameter 3 Ш 3 Ш 1 Ш 1 Ш +/-
Number 4 wire 3 wire 3 wire 2 wire
103 V L3-L1 (calculated) ✓
104 Average Line to Line Volts ✓ ✓
113 Neutral Current ✓ ✓ ✓
118 THD Volts 1 ✓ ✓ ✓ ✓
119 THD Volts 2 ✓ ✓ ✓
120 THD Volts 3 ✓ ✓
121 THD Current 1 ✓ ✓ ✓ ✓
122 THD Current 2 ✓ ✓ ✓
123 THD Current 3 ✓ ✓
125 THD Voltage Mean ✓ ✓ ✓ ✓
126 THD Current Mean ✓ ✓ ✓ ✓
3.15.6 Reading (Parameter Selection) - A1r or A2r
Use this screen to choose the parameter that the analogue
Output current will represent. The number displayed on the
screen is the Parameter Number shown in Table 2.
If the displayed Parameter Number is already correct, press >>
to move on to the next Set-up screen.
To change the Parameter Number, press and set the three-
digit number using the method described in Section 3.2
Number Entry Procedure.
Press >> to confirm your selection. The Confirmation screen
will appear.
If the new Parameter Number is correct, press >>. The next
Set-up screen will appear.
If not, press . You will be returned to the Parameter Selection
screen.
41
Integra 1540, 1000, 0640, 0440, 0340, 0240 Issue 1 04/03
Parameter Selection
Confirmation