Tektronix AFG3000 - Manual (Page 32)

Operating Basics
1-14 AFG3000 Series Arbitrary/Function Generators Reference Manual
Waveform Parameters and Numeric Input
This section explains how to set or change the waveform parameters of the
arbitrary/function generator using the front-panel controls or bezel menu selection.
Changing Parameters
Using the Bezel Menu
The arbitrary/function generator outputs a sine waveform of 1 MHz frequency with
1 V
p-p
by default. You can use the following two methods to set or change the
waveform parameters:
„ Using the bezel menu selection
„ Using the front-panel shortcut buttons (see page 1-17)
Figure 1-11 shows the default display of sine waveform.
Figure 1-11: Default display
Select the Frequency/Period/Phase Menu bezel button from the default display,
you can change the values of frequency, period, or phase.
Figure 1-12: Frequency/Period/Phase Menu