TransAct Technologies ITHERM 280 - Manual (Page 103)

iTherm ® 280 Programmer’s Guide Programming Codes
28-07764 Rev C Page 101
To allow other code pages to be created by an application, a redefine character set
command is provided.
As discussed above, there are two commands for language selection in IBM mode. The
first is [ESC] !, which selects one of 19 international character sets. The [ESC] !
command does not allow all of the possible character sets to be selected, it is provided
for compatibility with older programs only. The second is [ESC] [ T, which selects any
code page. In EPOS mode, the [ESC] R command has been expanded to select any
code page.
[ESC] ! Select international character set
ASCII
[ESC] ! <n>
Hexadecimal 1BH 21H <n>
Decimal
<27> <33> <n>
IPCL &%CS <n>
EPOS [ESC] R <n>
Description The [ESC] ! <n> command selects international character set <n>. In
standard mode, the value of <n> is as follows.
<n> Language <n> Language
64-‘@’ ASCII (slashed zero) 73-‘I’ Italian
65-‘A’ ASCII (unslashed zero) 74-‘J’ French Canadian
66-‘B’ British 75-‘K’ Spanish
67-‘C’ German 76-‘L’ Swedish II
68-‘D’ French 77 -‘M’ Swedish III
69-‘E’ Swedish 78-‘N’ Swedish IV
70-‘F’ Danish 79-‘O’ Turkish
71-‘G’ Norwegian 80-‘P’ Swiss I
72-‘H’ Dutch 81-‘Q’ Swiss II
Table 12 Language Table ID’s
[ESC] [ T Select character code page
ASCII
[ESC] [ T <n
h
> <n
l
>
Hexadecimal 1BH 5BH 54H <n
h
> <n
l
>
Decimal <27> <91> <84> <n
h
> <n
l
>
IPCL &%CP <m
1
> <m
2
> <m
3
> <m
4
>
EPOS [ESC] t <n>
Description The [ESC] [ T <n
h
> <n
l
> command selects character code page <n
h
>
<n
l
>. The iTherm ® 280 Printer supports many code pages. The following
code pages are supported.
Refer to Appendix A for a list of supported code page.