TransAct Technologies ITHERM 280 - Manual (Page 165)

iTherm ® 280 Programmer’s Guide Programming Codes
28-07764 Rev C Page 163
[ESC] x Open cash drawer
ASCII
[ESC] x <n>
Hexadecimal 1BH 78H <n>
Decimal
<27> <120> <n>
IPCL &%D1 (Cash Drawer 1)
&%D2 (Cash Drawer 2)
EPOS [ESC] p
Description The [ESC] x <n> command charges the cash drawer, <n>, for 150 ms.
Where <n> = <1> (01H) or 1 (31H) for Cash Drawer 1
<2> (02H) or 2 (32H) for Cash Drawer 2
The time period that drawer is activated can be changed in the
configuration menu. Activation time ranges from 25 ms to 250 ms.
Note 1: Cash drawer open commands are processed as part of print data.
They are not immediate commands and are not processed until found in
the input buffer by the print processor.
Note 2: Cash Drawer 2 is factory configurable in one of two modes. Either
pin 2 or 3 is active depending on an internal jumper setting. The factory
default is pin 3. Cash Drawer 1 is always on pin 2. The cash drawer
status is defined as an open circuit for drawer closed.
[ESC] v Perform Auto Cut
ASCII
[ESC] v
Hexadecimal 1BH 76H <n>
Decimal
<27><118>
IPCL &%FC &%PC
EPOS [ESC] i or [ESC] m
Description The [ESC] v command operated the auto cutter.
Note: The auto cutter is optional. If the auto cutter is not installed this
command will be ignored.
[ESC] @ Initialize the printer
ASCII
[ESC] @
Hexadecimal 1BH 40H
Decimal
<27> <64>
Description The [ESC] @ command initializes the printer. All settings, including
character font and line spacing, are canceled.