TransAct Technologies ITHERM 280 - Manual (Page 277)

iTherm ® 280 Programmer’s Guide ITherm® 280 Unicode and Fonts
28-07764 Rev C Page 275
[ESC] + P,
[ESC] + p Width
Not Zero From
Command From
command Based on
set character
spacing
command Will be used if
previously set
and character
spacing is not
being defined
by the font
[ESC] + I,
[ESC] + i Value 0 No effect No effect From Font Set Off but has
no effect
[ESC] + I,
[ESC] + i Value
Not zero No effect No effect From
Command Set Off
[ESC] + J,
[ESC] + j Value 0 No effect No effect From Font Set On but has
no effect
[ESC] + J,
[ESC] + j Value
Not zero No effect No effect A multiple of
the value
defined by the
command Set On
[ESC]I <n> From
POR.INI
definition From
POR.INI
definition As defined by
command Will be used if
previously set.