TransAct Technologies ITHERM 280 - Manual (Page 256)

iTherm ® 280 Programmer’s Guide ITherm ® 280 Color Graphics
Page 254 Rev C 28-07764
iTherm ® 280 Coupon-Cut-Logo Feature
The iTherm
® 280 printer has a feature that will allow a coupon and or logo graphic to
printed as part of the existing auto cutter command.
To activate this feature, it must first be configured. Configuration consists of specifying
in what order the Coupon-Cut-Logo is processed and optionally, how much paper is to
be feed after the new cut operation.
Once configured, the Coupon and/or logo must be defined and loaded into the printer.
The “Universal Graphics” feature should be used to define and load the graphic. The
Coupon is named “Coupon”, and the Logo is named “Logo”. They may be saved in any
resolution and of any size. They also need not be all graphics.
The existing application cut command will be replaced by the Coupon-Cut-Logo
operation. Configuration options are as follows:
Cut Command Logo:
Cut-Logo Perform Feed to cut, then cut, and then print the Logo.
Coupon-Cut Print the Coupon, Feed to Cut, and Cut.
Logo-Cut Print the Logo, Feed to Cut, and Cut.
Cut-Coupon Perform Feed to cut, then cut, and then print the Coupon.
Coupon-Cut-Logo Print the Coupon, Feed to cut, Cut, ad then print the Logo.
Logo-Cut-Coupon Print the Logo, Feed to cut, Cut, ad then print the Coupon.
Cut-Logo-Coupon Perform the Feed to cut, Print the Logo and then the Coupon.
Cut-Coupon-Logo Perform the Feed to cut, Print the Coupon and then the Logo.
Logo-Coupon-Cut Print the Logo, then the Coupon, feed to cut and Cut.
Coupon-Logo-Cut Print the Coupon, then the Logo, feed to cut and Cut.
Disabled Perform the Normal cut.
Cut Command Logo Feed: 0 to 80 mm.