TechniSat 1 User Manual
Page 14
The following adjustments can be made in this sub-menu:
5.4.1 Switch DiSEqC on or off
DiSEqC (
Di
gital
S
atellite
Eq
uipment
C
ontrol) is a digital control signal used to control and
switch DiSEqC-compatible components via the antenna cable.
If your external unit is equipped with DiSEqC components, you must switch on the DiSEqC-
control:
>
Make adjustments in this line by means of the key
OK DiSEqC on
or
off
.
Since only one LNB can be addressed when the DiSEqC control is switched off, the
menu is restricted to the configuration of a single LNB.
5.4.2 Setting the switching matrix and the LNB properties
The menu lists the four switching criteria of the DiSEqC control.
Your receiver has been pre-programmed, so that ASTRA will be received in switch position
A/A and Eutelsat in switch position B/A of a multiswitch. If the switching matrix of your recep-
tion equipment be configured differently, or if it is set to receive other satellites, you can
make the following settings/adjustments in your receiver.
>
Use the
arrow up/down keys
dto select the DiSEqC switch position (1-4) that you
want to allocate to a particular satellite (e.g.
A/B 3 No Satellite
), by marking this
line in blue.
>
Confirm by pressing
OK
.
A list of various satellites will now be displayed.
>
Use the
arrow up/down keys
to mark the satellite selected.
The
arrow up/down keys
will move the marker up or down one line at a time,
while using the
Parrow left/right keys
will jump to the previous or next page.
If the satellite you are looking for is not specifically listed, select one of the spare posi-
tions, marked as
User1
to
User 14
.
>
Confirm by pressing
OK
.
The selected and marked satellite will now be inserted and shown at the previously
marked position in the menu
>Settings>LNB
.
Continue to work your way through the
Menu >Settings>LNB
, until the data in this menu
corresponds with that of your reception unit. Any switching criteria not required should be set
to the position
No Satellite
.
5.4.3 Additional settings
Now that you have adjusted the switching matrix of your DVB receiver to correspond with
your reception unit, you should now check the additional parameters of your reception unit,
and, where necessary, make further corrections.
>
Use the
arrow left/right keys
to move the marker to the column
LNB-Test
.
>
Now use the
arrow up/down keys
, to mark the field
Continue
.in the line in
which you want to check or alter the settings.
>
Confirm by pressing
OK
.
The menu >
LNB>Check
will now be displayed, showing the DiSEqC setting selec-
ted (e.g.
A/A 1
).
14
DIGIBOX1_englisch.qxd 26.09.01 09:55 Seite 14