TechniSat 1 User Manual
Page 29
>
Confirm by pressing the
red
function key (“Start search”).
The scan will commence. Please note further information displayed on screen.
>
Press the
red
function key again to end the search.
7.4.4 Manual Search
If you are unable to find a specific programme by means of the search methods described
under 7.4.1 and 7.4.2, it may be necessary to enter additional programme-specific PID num-
bers for this programme. These numbers can be found either in the Internet, or you may
have to contact the programme provider to obtain the information.
To perform a manual search, call up the menu
>Search >Manual Search
.
>
Use the
arrow up/down keys
in order to mark the line
Manual Search
.
>
Confirm by pressing
OK
.
The menu
>Search>Manual Search
. will be displayed.
This menu differs from the
Transponder
nmenu only in terms of the menu points
PCR-
PID
,
Audio-PID
and
Video-PID
.
>
Proceed as described under Point 7.4.3.
>
Then, use the
arrow up/down keys
to mark the lines
PCR-PID
,
Audio-PID
and
Video-PID,
entering the appropriate numbers by means of the
numerical keys
.
7.4.5 After the scan
You can follow the scan of the transponder on screen while it is in progress. When the scan
is completed, the number of transponders found, the total number of programmes found as
well as the number of new programmes found will be displayed.
>
Press the
yellow
function key (“Select”) to access the main memory programme list,
in order to configure the programme lists.
>
Press the
green
function key to display a table of options.
>
Now use the
arrow up/down keys
to select
All
, to display all programmes, or
All
new
, to display only newly found programmes.
>
You can now proceed as described in Chapter 7.1 in order to distribute the individual
programmes to the various user lists.
7.5 Restore default basic programming/ Delete all
You can return to the default LNB settings, programmed at the factory, at any time. You may
also, if the programme list is out of date due to changes in the programme providers, delete
this completely, in order to carry out a new scan. Please note that after carrying out the Dele-
te function you must then run a programme scan, and then copy the desired programmes
from the main memory list into the various user lists.
>
Press the
Menu
key to display the
Main Menu
.
29
DIGIBOX1_englisch.qxd 26.09.01 09:55 Seite 29