TechniSat 1 - Manual (Page 22)

Proceed as follows with the programming:
Source
> Use the arrow keys to mark the column Source, then use the OK key to enter
the desired source ( TV or Radio ).
Channel
In this line you should select the TV channel on which you want to record a programme:
>
Mark the appropriate line
Channel
by means of the
arrow keys
.
> Press the OK .key.
A programme list will be displayed.
> Use the
arrow keys
to select the desired programme.
> Confirm by pressing OK .
The selected programme will now be taken over into the timer menu.
Date
> Use the
arrow keys
to mark the column
Date.
> Use the numeric keys to enter the date on which you wish to record a programme.
Start
> Use the arrow key right to mark the column Start .
> Use the
numeric keys
to enter the starting time for the timer in this line.
Stop
> Repeat the steps as described under “Start” to enter the stopping/ending time.
In order for all events to be considered, there should be a break of at least one minute
between the stopping time of one timer setting and the starting time of the next timer
setting!
Repeat (optional)
> Use the arrow key right to mark the column Rpt .
> Press the
OK
key.
A selection window will be shown, with several repeating suggestions.
1x Timer on
T Daily repeat
1xW
Repeat once a week
1-5 Repeat only on weekdays
6-7
Repeat only on weekends
> Select the desired function by means of the
arrow up/down keys
.
> The setting will be stored by pressing the OK key.
> When you have completed the programming, press the
yellow function key
in
22
DIGIBOX1_englisch.qxd 26.09.01 09:55 Seite 22