Technicolor - Thomson 210i - Manual (Page 12)

SpeedTouch 210i
8
Installation & Setup
Before You Start
♦
Use only the power adapter supplied by THOMSON (16-18 VAC/1A)
Using an incorrectly rated power adapter will result in damage to the router.
♦
Know the type of interface provided by your ISP or telecom. The standard model
only supports the ISDN BRI S/T-
interface. If you are an ISDN S/T-interface user,
you should have an NT-1 or NT-1 plus provided by your ISP or telecom.
Also, make sure the ISDN line is available.
♦
In case of emergency, unplug the power adapter first.
♦
Locate the device in a clean location. Do not block the ventilating slots on the rear
panel.
♦
Cables must be attached to the correct ports; to do otherwise may result in damage to
the router. Keep cables away from walkways.
♦
If you use S/T-interface, do not extend the ISDN line greater than 100 meters from
the NT-1 (NT-1 plus) box and the router.
♦
If you use DSL/Cable, check that your subscribed DSL/Cable modem supports the
Ethernet interface for connecting to your PC. If not, you will be unable to connect it to
the router.
Ordering Your ISDN Line
If you do not have an ISDN line installed already, we suggest that you order it from your
telephone company as soon as possible to avoid the long waiting period common when
ordering a new line. Use the information in this section to place the order. If you have
already installed your ISDN line, you can check the following section to make sure that
you can use all the features of your SpeedTouch 210i.
1. Contact your local telephone company’s ISDN Ordering Center.
2. Make sure DSS1 switches are available since these are the only switch types currently
supported by the SpeedTouch 210i.
3. When the telephone company installs your ISDN line, be sure to obtain the following
information: