Technicolor - Thomson 210i - Manual (Page 14)

SpeedTouch 210i
10
The SpeedTouch 210i Front Panel
Names and descriptions of your router’s front panel LEDs are given below:
SpeedTouch 210i
♦
POWER— Comes on as soon as you connect the router to the power
adapter and plug the power adapter into a suitable AC outlet.
♦
STATUS— Should be blinking if the router is functioning properly.
♦
ISDN – LINK— Indicates that the router has an ISDN line connected to
the ISDN interface and it has been successfully initialized.
Note: On some NT1 boxes, the LINK indicator will go off when the ISDN line has been
idle for a while. When the router is dialing or answering a call, it should be on again.
♦
ISDN – B1 and B2— On if there is an active ISDN session on that channel
or if that channel is making or receiving a call.
♦
LINK/ACT— 1 through 4 These indicators light up when a port is
connected to a powered-on Ethernet/Fast Ethernet station. The LEDs blink
when information is transmitted or received on a port.
♦
100/10M – 1 through 4 These indicators light up when a port is operating at
100Mbps. Otherwise, if this indicator is dark and the corresponding LINK
indicator is lit, then the port is operating at 10Mbps.
The SpeedTouch 210i Rear Panel
SpeedTouch 210i