Technicolor - Thomson 210i - Manual (Page 28)

SpeedTouch 210i
24
♦
Idle Timeout – Idle timeout means the router will disconnect after being idle
for a preset amount of time. The default is 180 seconds. If you set the time to 0,
the ISDN connection will remain always connected to the ISP.
IP Address Assignment Method (IPCP)
♦
Fixed IP and Fixed IP Address – In most environments you should not
change the default settings as most ISPs provide a dynamic IP address for the
router when it connects to the ISP. If your ISP provides a fixed IP address,
check Yes and enter the assigned IP address in the Fixed IP Address field.
Dialing to Dual ISPs
Most configuration parameters are the same as last section. This page provides an
"Enable Dual ISPs Function" check box and adds a secondary ISP Setup section.
Check the box and enter the second ISP information.
ISP Access Setup
♦
ISP Name – Enter the Internet Service Provider Name.
♦
Username – Enter the username obtained from your ISP provider.
♦
Password – Enter the password obtained from your ISP provider.
PPP/MP Setup
♦
Link Type – You have three selections:
Link Disable – Disables the ISDN dial-out function.
Dialup 128Kbps – Uses both ISDN B channels for Internet access.
Dialup BOD – BOD stands for bandwidth-on-demand. The router
will use only one B channel under low traffic situations. Once the single
B channel bandwidth is filled, the other B channel will be dialed