Technicolor - Thomson 210i - Manual (Page 54)

SpeedTouch 210i
50
Editing the Filter Rules
Click the Filter Rule index button to enter the Filter Rule setup page for each filter. The
following explains each configurable item in detail.
♦
Comments – Enter filter set comment/description. Its maximum length is 14
characters.
♦
Check to enable the Filter Rule – Enable the filter rule.
♦
Pass or Block – Specify the action to be taken when packets match the rule.
Block Immediately - Packets matching the rule will be dropped
immediately.
Pass Immediately - Packets matching the rule will be passed
immediately.
Block If No Further Match - A packet matching the rule and that does
not match further rules, will be dropped.
Pass If No Further Match - A packet matching the rule,
and that does not match further rules, will pass through.
♦
Branch to Other Filter Set – If the packet matches the filter rule, the next
filter rule will branch to the specified filter set.
♦
Duplicate to LAN – If you want to log the matched packets to another
network device, check this box to enable it. The MAC Address is defined in
General Setup
→
MAC Address for Packet Duplication.
♦
Log – Check this box to enable the log function. Use the Telnet command "log
-f" to view the logs.
♦
Direction – Set the direction of packet flow. For the Call Filter, this setting is
irrelevant.
IN: Specify the rule for filtering incoming packets.
OUT: Specify the rule for filtering outgoing packets.