Technicolor - Thomson 210i - Manual (Page 15)

SpeedTouch 210i
11
The SpeedTouch 210i has a power jack, an uplink port, four RJ-45 ports, an ISDN port
on the rear panel, and a factory reset button. Please note that only the THOMSON
supplied power adapter should be connected to the power jack.
♦
POWER — This socket is a 16-18 volt, 1000 mA power input jack. If the
power adapter included with the router has been lost or misplaced, please
ensure that the replacement adapter meets both the voltage and amperage
requirements.
♦
ETHERNET – The Ethernet ports function as a normal, dual speed NWay
Ethernet switch.
♦
Uplink – This port is used to connect the router to another
switch or hub using a straight-through twisted-pair cable. When
the Uplink port is used, Port 1x is unavailable.
♦
Ports 1x to 4x – These four ports can be used to connect end-
stations to the router using straight-through cables.
♦
ISDN – This socket is used to connect the ISDN line to an NT- 1.
♦
Factory Reset:
Switch on your SpeedTouch 210i.
The Status LED flashes.
To reset the SpeedTouch 210i to the factory settings: Press and hold the
button for 5 seconds when the unit is switched on. The Status LED will flash
more quickly – at this moment, release the button and the router is reset to its
factory settings.
Hardware Installation
Connecting the Power Adapter
1. Connect the power adapter to the electrical outlet in the wall and to the power jack on
the rear panel of the router.
2. The Status LED should be blinking once every 2 seconds.