Thermador CEP - Manual (Page 12)

English 8
To change cook settings when cooking:
1. Touch element display once. The display fl ashes
0.
2. Touch desired cook setting.
If a selection is not made within 5 seconds, the
Element will shut off.
To turn off the Zone Smart™ feature
If you want to use glass ceramic or ceramic cookware,
Have a pan smaller than 4 inches, or do not want to
use the pan detection / sizing feature, you can turn off
The Zone Smart™ system.
Glass ceramic and metal pans smaller than
4 inches:
1. Place pan on center of element.
2. Touch control pad for element desired.
3. Touch Zone Smart™ pad. Light goes off.
1. Place pan on center of element.
2. Touch the center of the control pad that
corresponds to the element desired. The display
fl ashes “0” and two lights to the left and right of
the display.
3. For dual and triple elements, touch the Pan Size
pad until desired element size is displayed.
• One touch of the pad will select the largest
element. The display will stop fl ashing and the
outer circle stays on.
• A second touch of the pad will select the small
element and the inner circle stays lit.
• For the triple element, another touch of the pad
and the middle element is selected.
• Further touches of the pad will toggle through the
selection process.
4. Touch desired heat setting. The display shows the
heat setting selected and starts heating.
5. To turn off a surface element, touch the element
display area twice OR…
To turn off all elements at the same time, touch the
Power Pad.
4. For single elements, omit this step. For dual
elements, touch Pan Size until desired pan size is
displayed. See Step 3 below. Setting the Controls
– CEF and CET Models
5. Touch desired heat setting.
6. Element starts heating.
Metal pans larger than 4 inches:
1. Place pan on center of element.
2. Touch control pad for element desired.
3. Touch desired setting.
4. Touch Zone Smart™ pad. Light goes off.
5. Pan size and heat setting are kept in memory.
6. The element starts heating.
Setting the Controls - Zone Smart™
Setting the Controls - CEF and CET Models
Cooktop Operating Instructions