TP-Link TL-WA5110G - Manual (Page 29)

21
Figure 4-9 MAC Address Clone
Some ISPs require that you register the MAC Address of your adapter, which is connected to your
cable/DSL Modem or Ethernet during installation. Changes are rarely needed here.
¾ WAN MAC Address - This field displays the current MAC address of the WAN port, which is
used for the WAN port. If your ISP requires that you register the MAC address, please enter
the correct MAC address into this field. The format for the MAC Address is
XX-XX-XX-XX-XX-XX (X is any hexadecimal digit).
¾ Your PC's MAC Address -
This field displays the MAC address of the PC that is managing
the router. If the MAC address is required, you can click the Clone MAC Address To button
and this MAC address will fill in the WAN MAC Address field.
Click Restore Factory MAC to restore the MAC address of WAN port to the factory default
value.
Click Save to save your settings.
)
Note:
1) Only the PC on your LAN can use the Clone MAC Address To feature.
2) If you click Save, the router will prompt you to reboot.
4.6 Wireless
Figure 4-10 Wireless menu
There are eight submenus under the Wireless menu (shown in Figure 4-10):Basic Settings,
Wireless Mode, Security Settings, MAC Filtering, Wireless Statistics, Distance Setting,
Antenna Alignment
and Throughput Monitor. Click any of them, and you will be able to
configure the corresponding function. The detailed explanations for each submenu are provided
below.
4.6.1 Basic Settings
The basic settings for the wireless network in AP Client Router operation mode are set on this
page.