TP-Link TL-WA5110G - Manual (Page 64)

56
Figure 4-56 Speed Test
¾ Destination IP : The Remote device’s IP address.
¾ Advanced options : This is switch to show advanced test options which are used only for
precise estimation.
¾ User : Administrator password of the remote device. It should be filled correctly if you want to
get a precise estimation. Otherwise, keep it blank.
)
Note:
If either User or Password is incorrect, we will take a basic test instead. In other words, none of
the advance options you set will take effect.
¾ Direction : There are 3 options available for the traffic direction while estimating the
throughput.
z transmit -Estimate the outgoing throughput (TX).
z receive
- Estimate the ingoing throughput (RX).
z both
- Estimate the incoming (RX) first and then the outgoing (TX) afterwards.
¾ Duration : The value you specify here indicate how much time the test should last.
¾ Data amount : The maximal data amount to be sent out during the whole test.
)
Note:
If both Duration and Data amount are specified, the test will stop after any of them is met.
Be sure to click the Run Test button to start a new test after you filled enough information. You
can also stop a running test by click Stop Test button at any time.
4.13.7 Reboot
This page (shown in Figure 4-57) allows you to reboot the router.