TP-Link TL-WA5110G - Manual (Page 56)

48
the router from the LAN port. The default value is disabled. If enabled, the ping packet from
the LAN port cannot access the router. (Defends against some viruses)
Click the Save button to save the settings.
Click the Blocked DoS Host Table button to display the DoS host table by blocking. The page
will appear that shown in Figure 4-44:
Figure 4-44 Thwarted DoS Host Table
This page shows Host IP Address and Host MAC Address for each host blocked by the router.
¾ Host IP Address- The IP address that blocked by DoS are displayed here.
¾ Host MAC Address - The MAC address that blocked by DoS are displayed here.
To update this page and to show the current blocked host, click on the Refresh button.
Click the Clear All button to clear all displayed entries. After the table is empty the blocked host
will regain the capability to access the Internet.
Click the Back button to return to the Advanced Security page
4.11 Static Routing
A static route is a pre-determined path that network information must travel to reach a specific
host or network. To add or delete a route, work in the area under the Static Routing page (shown
in Figure 4-45).
Figure 4-45 Static Routing
To add static routing entries:
1. Click the
Add New
button. (pop up Figure 4-46)
2. Enter the following data:
¾ Destination IP Address - The Destination IP Address is the address of the network or host
that you want to assign to a static route.
¾ Subnet Mask - The Subnet Mask determines which portion of an IP Address is the network
portion, and which portion is the host portion.
¾ Default Gateway
- This is the IP Address of the gateway device that allows for contact
between the router and the network or host.