USRobotics U.S. Robotics SureConnect ADSL Ethernet/USB Router User Manual
Page 114
U.S. Robotics SureConnect ADSL Ethernet/USB Router User Guide
Enter 4 at the SNDCP Menu. The PPPoE Menu appears. This menu provides the following
options…
●
List PPPoE. Enter 1 at the PPPoE Menu. The List PPPoE Menu appears. This menu
displays configured PPPoE variables.
●
Configure PPPoE. Enter 2 at the PPPoE Menu. The Configure PPPoE Menu appears.
This is a two-screen menu. Set these PPPoE variables...
Configure PPPoE, Screen 1
Configure PPPoE, Screen 2
§
Profile ID [0-7]
§
Restart Time
§
Interface Name [ ppp [0-7] ]
§
Mode [Auto/Direct]
§
Vpi [0-255]
§
Idle Timeout
§
Vci [0-65,535]
§
My IP Address
§
Encapsulation Type [11c/vc]
§
Peer IP Address
§
User Name
§
Service Name
§
Password
§
AC Name
§
Authentication Protocol
[pap/chap/mschapv1/mschapv2]
§
Host Unique Tag [Y/N]
§
MRU [0-1,492]
§
Ether Address
§
MTU [0-1,492]
§
Enable Nat [Y/N]
§
§
SubnetMask
After you complete your configuration, proceed to the Basic Menu and enter 8. The Save &
Reboot Menu appears. From this menu, save your changes and reboot the router.
•
Start PPPoE. Enter 3 at the PPPoE Menu. The Start PPPoE Menu appears. This menu
allows you to start a PPPoE session by entering the session’s profile ID.
•
Stop PPPoE. Enter 4 at the PPPoE Menu. The Stop PPPoE Menu appears. This menu
allows you to stop a PPPoE session by providing the session’s profile ID.
•
Delete PPPoE. Enter 5 at the PPPoE Menu. The Delete PPPoE Menu appears. This menu
allows you to delete a PPPoE session by entering the session’s profile ID.
•
Default PPPoE. Enter 6 at the PPPoE Menu. The Default PPPoE Menu appears. This
menu allows you to make a PPPoE session the default session by providing the session’s
profile ID.
file:///P|/T_WRITER/Documentation/Released/900...9003%20(Guiness)%20prac%20template/tquicks.htm (32 of 42) [11/6/2002 8:58:14 AM]