USRobotics U.S. Robotics SureConnect ADSL Ethernet/USB Router - Manual (Page 67)

U.S. Robotics SureConnect ADSL Ethernet/USB Router User Guide
O/I Pushbutton switch that turns the U.S. Robotics SureConnect ADSL
Ethernet/USB Router on and off.
Power Input jack that accepts cable from wall power supply.
Console Connects an RS-232 cable (not included) to the router. You can use the cable
to communicate to the router through the Terminal User Interface. The Terminal
User Interface (TUI) is another way to configure the router or get diagnostic
information. The TUI substitutes for the Web User Interface.
USB Universal serial bus port on the back of the router.
ENET1 Ethernet Port 1 on the back of the router.
ENET2 Ethernet Port 2 on the back of the router.
ADSL Digital subscriber line RJ-11 service jack on the back of the router.
Connect the Power Adapter
Be sure to only use the included power supply. Connect the power adapter cord to the
“Power” jack at the rear of the router. Connect the power adapter to a standard wall outlet.
Turn on the router by pressing the power button labeled “O / I.” The “PWR” LED on the front
panel of the U.S. Robotics ADSL Ethernet/USB Router will be illuminated if power is being
supplied to the router. The router will initialize after the power is plugged in. This process
takes about a minute. Click Next to initialize the router.
file:///P|/T_WRITER/Documentation/Released/9003%20(Guinness)/User%20Guide/9003%20(Guiness)%20prac%20template/installa.htm (10 of 25) [11/6/2002 8:55:05 AM]