Vanguard Managed Solutions Vanguard 7300 Series - Manual (Page 179)

Replacing Power Supplies and Cooling Fans 6-5
Replacing Power Supplies and Cooling Fans, 7310 Version 1
Removing and Installing the Exhaust Fan Module
Introduction The Vanguard 7310 Version 1 Exhaust Fan Module contains the rear exhaust fans.
The module is hot-swappable; it can be removed without turning off the system
power and without disrupting system service.
This section describes how to remove or install the Exhaust Fan Module.
Procedure Refer to Figure 6-4 and these steps to remove the Exhaust Fan Module:
Note
The Exhaust Fan Module is hot-swappable and can be removed without
disconnecting the power source and without disrupting system service.
1) Loosen the single captive screw above the front ESD bonding point.
2) Carefully pull on the module handle to withdraw the module out the front of the
chassis and away from the midplane.
Figure 6-4. Removing the Vanguard 7310 Version 1 Exhaust Fan Module
Front of Chassis
Captive Screw
Exhaust Fan
Module