Vanguard Managed Solutions Vanguard 7300 Series - Manual (Page 93)

Vanguard 7300 Installation 3-19
Attaching a Vanguard 7300 AC Power Cord
Attaching a Vanguard 7300 AC Power Cord
Introduction This section explains how to attach an AC Power Cord to a Vanguard 7310 or 7330.
Attaching the
Power Cord Attach the supplied power cord to the rear of the AC power supply and plug it in.
The Vanguard 7310 Version 1 power receptacle is on the back of the enclosure. See
Figure 3-13.
Figure 3-13. Vanguard 7310 Version 1 - Power Connector and On/Off
Switch
Version 1 For the Vanguard 7330 Version 1 routers, there are two AC power cords on the back
of the enclosure, one for each of the two AC power supplies, as shown in
Figure 3-14. The power switch for the Vanguard 7330 is on the chassis front panel.
Figure 3-14. Vanguard 7330 Version 1 - Power Connectors
Power
Switch
Dual Earth
Ground
ESD Bond
Point
AC Power
Receptacle
AC Power Cord
Receptacles