Vanguard Managed Solutions Vanguard 7300 Series - Manual (Page 89)

Vanguard 7300 Installation 3-15
Installing the Vanguard 7300 in a Rack
Installing the Vanguard 7300 in a Rack
Introduction This section explains how to install a Vanguard 7300 router chassis in an industry-
standard 19-inch EIA equipment rack.
Note
Vanguard 7300 Series routers are not to be used standalone on a tabletop or
stacked on top of one another.
Warning
Two people are required to install a Vanguard 7300 Series router in an equipment
rack. To prevent personal injury or damage to equipment, mount the router no higher
than the mid-point of the rack.
Grounding the
Vanguard 7300 Be sure to mount the chassis with mounting hardware that give a good electrical
connection between the screws or bolts and the mounting surface.
Caution
Failure to observe proper grounding practices may cause a variety of noise,
electrostatic discharge and RFI (Radio Frequency Interference) problems.
Caution
Avoid touching areas of integrated circuitry. Static discharge can damage circuits.
Caution
Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the “ESD
Bond Point” on the front or rear of the chassis as a ground. Secure the ESD strap to
your wrist and to ground throughout any installation procedures.
Avertissement
Deux personnes sont nécessaires pour le montage d’un routeur Vanguard série 7300
dans un cadre d’équipement.
Ne montez pas le routeur plus haut que le centre du cadre pour empêcher des
blessures ou des dommages à l’équipement.
Achtung
Es werden zwei Personen benötigt, um einen Vanguard 7300 Series Router in
einen Einschubschrank einzubauen.
Um Verletzungen des Personals oder Beschädigungen des Geräts vorzubeugen, darf
der Router höchstens in mittlerer Höhe des Einschubschrankes montiert werden.