Vanguard Managed Solutions Vanguard 7300 Series - Manual (Page 181)

Replacing Power Supplies and Cooling Fans 6-7
Replacing Power Supplies and Cooling Fans, 7330 Version 1
Removing the Fan Tray
Introduction This section explains how to remove and replace the two cooling fans in the hot
swap fan tray beneath the module cage. The fan tray can be hot-swapped.
Caution
Avoid overheating by installing the replacement fan tray immediately.
Procedure Refer to Figure 6-5 and the steps in this table to remove the cooling fan tray:
Figure 6-5. Installing or Removing the Fan Tray
Step Action
1 Loosen the two captive screws securing the fan tray vent to the chassis.
2 Begin sliding the fan tray away from the front of the chassis. This
automatically disengages the fan from the midplane connector.
3 Allow the fans to stop rotating before removing the fan tray.
Fan Tray