Xantrex Technology PROsine 2.0 - Manual (Page 45)

Safety Instructions
445-0089-01-01 3–3
Installation Tools and Materials
You will need the following to install the PROsine, display panel, and battery
temperature sensor:
p Wire stripper
p Mounting screws or bolts
p #2 Phillips screwdriver
p Wrench for DC terminals (1/2 inch or 13mm or adjustable)
p AC cable (i.e. 2-conductor-plus-ground cable), sized appropriately for load
and application
p Wire nuts or crimp connectors for AC wire and appropriate tools
p Two 1/2 inch strain-relief clamps for AC cables
p DC cable, sized appropriately for load and application
p Lugs for DC cables to fit 8 mm (5/16 in.) DC stud terminals) as well as
appropriate tools (e.g. crimping tool)
p AC and DC disconnects and over-current protective devices
Installation Procedures
This section provides detailed installation information. For your convenience, the
overall procedure is divided into ten main steps:
p Step 1: Designing an installation. (Start on page 3–4.)
p Step 2: Choosing a location for the PROsine. (Start on page 3–9.)
p Step 3: Mounting the PROsine. (Start on page 3–10.)
p Step 4: Connecting the AC input wiring. (Start on page 3–11.)
p Step 5: Configuring the output neutral bonding system. (Start on page 3–13.)
p Step 6: Connecting the AC output wires. (Start on page 3–15.)
p Step 7: Connecting the DC cables. (Start on page 3–17.)
p Step 8: Mounting the display panel. (Start on page 3–20.)
p Step 9: Connecting the battery temperature sensor. (Start on page 3–21.)
p Step 10: Connecting the remote shutdown feature. (Start on page 3–24.)
Important: For residential installations, installation codes may require a wiring
enclosure for DC connections and cables. Contact Xantrex or your distributor for this part.